Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterCWS Roof Replacement & Installation in Fort Pierce: What to Know First
CWS roof replacement and installation in Fort Pierce means replacing or installing the roof-mounted components of a CWS window or door system, typically the header flashing, drip cap, and the seal where the frame meets the roofline. As an independent CWS service provider, TruePane Windows & Doors handles these jobs with a straightforward approach: most CWS roof-related replacements in Fort Pierce run between $400 and $1,900 depending on the opening size, flashing condition, and whether the decking or underlayment needs attention once we open the wall. Call (772) 218-5890 for a free estimate.
This page is for the homeowner who has a CWS window or door that’s leaking at the top edge, showing water stains on the interior drywall below the header, or failing after the last roofer “flashed around it.” If that sounds familiar, you’re in the right place.
How CWS Products Fail - and How We Fix Them
CWS builds a solid window and door, but roof replacement and re-roofing jobs expose weaknesses that no manufacturer brochure covers. Here’s what we find in Fort Pierce homes.
- CWS 800 Series single-hung windows with cap flashing pulled loose. During re-roofs, roofing crews often bend or pry the existing drip cap to tuck new shingles. We see CWS 800 frames where the cap was never re-secured, leaving a channel that funnels water straight behind the frame on the next hard rain off the Atlantic. We remove the old cap, inspect the nailing fin and header seal, and set a new cap bedded in flashing-grade sealant that won’t shrink in Florida heat.
- CWS sliding glass doors with a roofline leak, not a door leak. Homeowners call us about a “door leak” when water pools at the threshold. On CWS sliders installed under shallow eaves, the problem is often the roofline flashing above the header letting water run down inside the wall cavity and exit at the door. Our fix addresses the top of the opening first, then we re-level the track and check the weep system before calling it done.
- Warped header flashing on CWS casement windows after hurricane season. Fort Pierce’s sun and salt take a toll. Flashing that was fine at install warps and separates at the corner laps after a few seasons of thermal cycling. We replace it with heavier-gauge material and lap the corners properly, sealing each lap.
- Failed sealant at the roof-to-frame junction on CWS picture windows. The gap between the roof edge and the top of a fixed CWS picture window is a common entry point. Builders caulk it once and forget it. We see cracked, shrinking caulk beads that let water ride the frame down to the interior sill. We cut out the old bead, clean the joint, and re-seal with a product rated for continuous Florida sun and intermittent salt spray.
- Roof decking rot discovered behind the CWS frame during replacement. Once we pull the trim and flashing on a replacement job, we sometimes find the roof decking adjacent to the frame has absorbed water for years without showing interior signs. We quote what we find on paper before touching the rotted section, then replace the affected decking and re-flash with a proper water-shedding lap. If the pane is not true, the job is not done.
Our CWS Roof Replacement & Installation Process
We follow the same sequence on every CWS roof-related job, whether it’s a single window or a full door replacement.
- 1
Call and schedule. A live person answers, 24/7. We ask what you’re seeing, when it started, and whether a roofer has been on the roof recently. That last question often tells us more than the first two.
- 2
On-site inspection. Our technician arrives uniformed and background-checked. We inspect the CWS unit, the roof flashing above it, and the interior wall below it. We measure every opening twice.
- 3
Written quote. You get a line-item price on paper before any work starts. No surprises on the bill, no fine print that covers neither of us.
- 4
Replacement and flashing work. We remove the old flashing and any damaged trim, replace rotted decking if found, install new CWS-compatible flashing and sealants, and set the frame back true before securing it.
- 5
Water test and cleanup. We run water over the repaired area to confirm the seal holds, then clean the job site.
- 6
Warranty registration. Before the truck leaves your driveway, both manufacturer warranty layers are registered in writing and the Done Right Promise applies to every part of our work.
What CWS Roof Replacement & Installation Costs in Fort Pierce
Here’s what we charge for the common scenarios, based on what we see in Fort Pierce homes built from the 1980s through the mid-2010s.
- Header flashing replacement on a single opening: $400-$650
- Flashing and re-seal on two or three openings: $900-$1,600
- Full CWS window replacement including roof flashing and rotted decking repair: $1,200-$1,900 per opening
- CWS sliding door roof flashing and track re-level: $800-$1,500
What moves the price: opening size, whether the decking is rotted, access height, and whether we’re matching existing trim or replacing it. Call (772) 218-5890 for a written line-item quote. Estimates are free.
Why Fort Pierce Homeowners Call TruePane Windows & Doors for CWS Work
We’ve served the Treasure Coast since 2008, and we’ve been in enough Fort Pierce homes to know that a CWS window installed wrong will fail right after the first hard rain. That’s why we register both warranty layers in writing before the truck leaves the driveway, and why our Done Right Promise means what it says: if it’s not done right, we make it right, no paperwork and no arguing. We also carry PGT, CGI, ES Windows, and ECO Window Systems lines for homeowners ready to replace a CWS unit with an impact-rated upgrade. A live person answers every call, day or night.
FAQs
As an independent service provider, we’re not authorized by CWS to make warranty determinations, but the flashing and sealant work we do is external to the CWS unit itself and does not alter its frame, glass, or hardware. If there’s a question, call us and we’ll tell you what we see before doing anything.
If the frame is sound, re-flashing and re-sealing runs $400 to $1,000. If the frame has rotted from years of water intrusion, replacement is the honest answer. We’ll tell you which one applies to your opening. Call (772) 218-5890 for a free inspection.
We keep common CWS-compatible flashing profiles, sealants, and hardware on hand for most Fort Pierce area homes. For OEM CWS parts, we source directly from available supplier channels. If we need a part that won’t arrive for a few days, we’ll tell you on the spot.
A single opening typically takes a half day. A full door or multiple windows may run a full day. We give you a schedule before we start and we stick to it. That’s the standard.
We’ll match frame color, grid pattern, and glass package as closely as current availability allows. If CWS has discontinued the line, we’ll show you the closest PGT or CGI equivalent on paper before any work starts. If it is not right when the caulk dries, it will not be right in two years either.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Fort Pierce and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.